Instructions for Remotes with Mode Switch only (HW1011 and HW2011)
Reprogramming your Remote:
First - Make sure your battery is fully charged
to approx. 7.25 volts. Remote will not operate
below 3 volts. (Check your battery with a
volt/multi-meter to insure the proper voltage.)
About 90% of the calls we get for remotes
stem from improperly charged batteries.
Step 1 - Clearing Memory
Static electricity can cause your remote
to have to be programmed. First you press
the Mode Switch (the button on the back of
the receiver, inside the duck) and hold it
down. The green light will start blinking.
Release the Mode Switch and wait 3 seconds.
Press Mode Switch down again and hold until
the green light blinks slowly 2 times. Release
Mode Switch. Memory is now cleared. Next
you have to learn the transmitter code.
Step 2 - Learning the Transmitter Code
Transmitter (key pad) and receiver are pre-coded
to work together. For the receiver to relearn
a lost (or new) transmitter code, you will
press the Mode Switch and hold it down until
the receiver’s light starts to flash. Release
the Mode Switch. Press the transmitter (key
pad) button one time only and release. The
light on the receiver will flash once and
go out. Press the transmitter (key pad) button
one time and release. The motor will now
operate. If the motor does not operate press
the on/off button under the tail of the duck.
On multi-cycle remote press button 1 on transmitter
(key pad)
Important
Note: The receiver and transmitter are not
waterproof and must be kept dry.
Note: At the end of operation, turn your
decoy off using the remote control. DO NOT
turn the decoy’s on/off switch off. Otherwise,
it will continue to drain your battery.
Note: The transmitter has its own battery.
If the red LED light does not appear when
transmitter button is pushed then replace
the battery. (12 v Duracell #MN21/A23 or
Radio Shack # 23-154 ).
Instructions for Remotes without Mode Switch
This remote transmitter has a telescoping
antenna and MOJO embossed in the receiver.
(For identification purposes)
First - Make sure your battery is fully charged to approx. 7.25 volts. Remote will not operate
under 3 volts.
Reprogramming your remote:
Simply disconnect the positive wire (red
wire) from your battery for 30 seconds. Now
connect positive wire back to battery and
press the (on) button on your transmitter.
If motor does not operate push the on/off
button under the tail of your duck.
Important
Note: The receiver and transmitter are not
waterproof and must be kept dry.
At the end of operation, turn your decoy
off using the remote control. DO NOT turn
the decoy’s on/off switch off. Otherwise,
it will continue to drain your battery.